Our gutter is roll-formed in 26 gauge StarGaurd 10 or Ultra Premium-20 finished steel. A strippable film is then applied for protection in shipment. Lengths of up to 20' are available. The size of the gutter is larger to allow proper drainage of wide buildings. One end is swedged for ease of erection. Corners are mitered.

Downspouts are 4" x 5" or 3" x 4" roll-formed steel, colored to match the wall panel and sized to match the gutter capacity. Downspouts come in 10' lengths with swedged ends.

Our gable trim is roll-formed in the same profile as the eave gutter. It has strippable film applied for protection and comes with swedged ends. Lengths of up to 20' are available. Different gable trim is used with various roof panels. Corners are mitered. Our gable trim has a specially designed drip edge to prevent streaking of the wall panels.

We use various metal rib fillers to fill the gaps in panel corrugations. Both inside and outside rib fillers are furnished with gable trim, facades and accessories.

The mitered eave panel is a exclusive for Dura-Rib and StarMark wall panels. This trim miters the wall panel corrugations into the roof corrugations. Gun type caulking is used to seal the joint.

We furnish base trim with all wall panels. Optional trim is available for use with masonry or any other place wall panel touches other materials.

The Dura-Rib roof is capped with a dieformed ridge cap shaped to conform to the roof panel corrugations. Special reduced yield steel is used for the ridge cap panel to prevent cracking..